 |
Step # 1
Put the ATV in first gear. Stand in front of the ATV. Grab the front bumper
with both hands & lift the front of the ATV until it stands on the Rear
Grab Bar. |
 |
Step # 2
The Frame Hooks on our stands are designed to fit the cross tubing on the
bottom of the ATV frame under the camlock hooks. Adjust the Frame Hooks on
the stand to the correct width for each ATV. Hold the stand in place and
attach the Front Ratchet Tie Down to the front of the ATV frame or bumper,
then attach the two other Tie Downs to the Foot Pegs. After all three Tie
Downs are attached; tighten them evenly until the stand is secured solid to
the bottom of the ATV. |
 |
Step # 3
Stand in front of the ATV, grab the front bumper with both hands and lower
it forward until the back legs of the ATV Stand touch the ground. This is
first position the ATV will sit for working on the front suspension, tie
rods, etc. |
 |
Step # 4
Stand in front of the ATV, grab the front bumper with both hands and lower
it forward until all four legs of the ATV Stand touch the ground. Now,
tighten all three Tie Downs one more time. This is the Second position for
working on your ATV. |
 |
Step # 5
Removing the ATV from the stand is simple. Put ATV in first gear. Grab the
front bumper and lift up until the rear tires are on the ground. Then push
on the bumper until the ATV is in the upright position on the Rear Grab
Bar. Remove the Stand and lower the ATV back onto all four wheels. |
